米6体育平台手机版

SNVA966 July 2020 – MONTH LP8864-Q1 , LP8864S-Q1 , LP8866-Q1 , LP8866S-Q1

Trademarks
1Fault Handling Routine
2Different Fault and Diagnostic Handling Method Recommendation
1. 2.1 Different Fault Handling Method
2. 2.2 Different Diagnostic Wrong Information Handling Method
  1. 2.2.1 System-Level Critical Wrong Diagnostic Information
  2. 2.2.2 System Level Sustainable Wrong Diagnostic Information
3Summary
A Fault-Related Functions
1. A.1 Protection and Fault Detections
  1. A.1.1 Supply Faults
    1. A.1.1.1 VIN Undervoltage Faults (VINUVLO)
    2. 16
    3. A.1.1.2 VIN Overvoltage Faults (VINOVP)
    4. A.1.1.3 VDD Undervoltage Faults (VDDUVLO)
    5. A.1.1.4 VIN OCP Faults (VINOCP)
    6. A.1.1.5 Charge Pump Faults (CPCAP, CP)
    7. A.1.1.6 Boost Sync Clock Invalid Faults (BSTSYNC)
    8. A.1.1.7 CRC Error Faults (CRCERR)
  2. A.1.2 Boost Faults
  3. A.1.3 LED Faults
    1. A.1.3.1 Open LED Faults (OPEN_LED)
    2. A.1.3.2 Short LED Faults (SHORT_LED)
    3. A.1.3.3 LED Short to GND Faults (GND_LED)
    4. A.1.3.4 Invalid LED String Faults (INVSTRING)
    5. A.1.3.5 I2C Timeout Faults
  4. A.1.4 Overview of the Fault and Protection Schemes
2. A.2 Programming Examples
  1. A.2.1 Clearing Fault Interrupts
  2. A.2.2 Disabling Fault Interrupts
  3. A.2.3 Diagnostic Registers

2.2.2 System Level Sustainable Wrong Diagnostic Information

The following incorrect diagnostic information indicates that something is wrong with the system. If only the following diagnostic information is detected, the system may continue working. These include:

VBOOST_STATUS calculated voltage is out of expected LED voltage range
AUTO_PWM_FREQ_SEL is different from system intended settings
AUTO_LED_STRING_CFG is different from system intended settings
AUTO_BOOST_FREQ_SEL is different from system intended settings
MODE_SEL is different from system intended settings

Software could try power cycling the chip once. If the fault is still not recovered, the system may continue working until other faults are detected. However, some problems like brightness degradation, higher EMC, and audible noise might occur if the system keeps working. The engineer should decide whether the system could keep working with such problems based on the specified system requirement.