3.2 Boost Mode Power-Up and Power-Down Sequence

1. Refer to Table 2 through Table 5 for proper jumper settings.
2. Turn on the HV-PS power supply and HV-E-Load.
3. Turn on the LV-PS power supply.
4. Apply a voltage > 2.5 V and < 6 V at J17-pin 5 (Master Enable).
5. Apply an analog voltage gradually rising from 0 V to 1.5 V at J17-pin 11 or J18-pin 11 (ISETA), or a PWM signal of duty ratio of 0 to 48% at J17-pin 13 or J18-pin 13.
6. Perform the test.
7. After the tests are done, turn off the ISETA or ISETD signal, remove the voltage at J17-pin 5, and turn off the E-Load, HV-PS and LV-PS.