SNVU803 May 2022 LP87562-Q1

1 Introduction

This technical reference manual can be used as a reference for the LP87562R-Q1 default register bits after OTP memory download. This technical reference manual does not provide information about the electrical characteristics, external components, package, or the functionality of the device. For this information and the full register map, refer to the LP8756x-Q1 Four-Phase 16-A Buck Converter With Integrated Switches data sheet.

Table 1-1 lists the main OTP settings for power rails. Table 2-1 lists the register bits loaded from OTP memory.

Table 1-1 Main OTP Settings for Power Rails

Description		Bit Name	LP87562RRNFRQ1 Value
Device identification	OTP configuration	OTP_ID	A7h
BUCK0, BUCK1, BUCK2 (3-phase operation)	Output voltage	BUCK0_VSET	850 mV
	Enable, EN pin, or I²C register	EN_BUCK0, EN_PIN_CTRL0, BUCK0_EN_PIN_SELECT	EN1
	Force PWM	BUCK0_FPWM	Yes
	Force multiphase	BUCK0_FPWM_MP	Yes
	Peak current limit per phase	ILIM0,ILIM1,ILIM2	5 A
	Maximum load current	N/A	12 A
	Slew rate	SLEW_RATE0	3.8 mV/µs
BUCK3	Output voltage	BUCK3_VSET	800 mV
	Enable, EN pin, or I²C register	EN_BUCK3, EN_PIN_CTRL3, BUCK3_EN_PIN_SELECT	EN1
	Force PWM	BUCK3_FPWM	Yes
	Peak current limit	ILIM3	5 A
	Maximum load current	N/A	4 A
	Slew rate	SLEW_RATE3	3.8 mV/µs
Switching frequency		N/A	2 MHz
I²C address		N/A	63h

Note:

The maximum total output capacitance (local + POL) per phase (BUCK0, BUCK1, BUCK2, and BUCK3) depends on the slew rate setting. Check the data sheet for the allowed capacitance value.