SNVU828 March 2022 LP87562-Q1

3 Register Bits Loaded From OTP Memory

Table 3-1 lists all the default register bit values loaded from the OTP memory during device start-up.

Table 3-1 Summary of Register Values

Address	Register Name	Bit	Value	Description
0x01	OTP_REV	OTP_ID[7:0]	D2h	D2h
0x02	BUCK0_CTRL1	EN_BUCK0	01h	Enabled
0x02	BUCK0_CTRL1	EN_PIN_CTRL0	01h	EN1 pin
0x02	BUCK0_CTRL1	BUCK0_EN_PIN_SELECT[1:0]	00h	EN_BUCK0 bit AND EN1 pin
0x02	BUCK0_CTRL1	BUCK0_FPWM	01h	Forced PWM
0x02	BUCK0_CTRL1	BUCK0_FPWM_MP	01h	Forced multi-phase operation
0x03	BUCK0_CTRL2	ILIM0[2:0]	07h	5.0 A
0x03	BUCK0_CTRL2	SLEW_RATE0[2:0]	04h	3.8 mV/us
0x04	BUCK1_CTRL1	EN_BUCK1	01h	Enabled
0x04	BUCK1_CTRL1	EN_PIN_CTRL1	01h	EN1 pin
0x04	BUCK1_CTRL1	BUCK1_EN_PIN_SELECT[1:0]	00h	EN_BUCK1 bit AND EN1 pin
0x04	BUCK1_CTRL1	BUCK1_FPWM	01h	Forced PWM
0x05	BUCK1_CTRL2	ILIM1[2:0]	07h	5.0 A
0x05	BUCK1_CTRL2	SLEW_RATE1[2:0]	04h	3.8 mV/us
0x06	BUCK2_CTRL1	EN_BUCK2	01h	Enabled
0x06	BUCK2_CTRL1	EN_PIN_CTRL2	01h	EN1 pin
0x06	BUCK2_CTRL1	BUCK2_EN_PIN_SELECT[1:0]	00h	EN_BUCK2 bit AND EN1 pin
0x06	BUCK2_CTRL1	BUCK2_FPWM	01h	Forced PWM
0x06	BUCK2_CTRL1	BUCK2_FPWM_MP	01h	Forced multi-phase operation
0x07	BUCK2_CTRL2	ILIM2[2:0]	07h	5.0 A
0x07	BUCK2_CTRL2	SLEW_RATE2[2:0]	04h	3.8 mV/us
0x08	BUCK3_CTRL1	EN_BUCK3	01h	Enabled
0x08	BUCK3_CTRL1	EN_PIN_CTRL3	01h	EN2 pin
0x08	BUCK3_CTRL1	BUCK3_EN_PIN_SELECT[1:0]	01h	EN_BUCK3 bit AND EN2 pin
0x08	BUCK3_CTRL1	BUCK3_FPWM	01h	Forced PWM
0x09	BUCK3_CTRL2	ILIM3[2:0]	07h	5.0 A
0x09	BUCK3_CTRL2	SLEW_RATE3[2:0]	04h	3.8 mV/us
0x0A	BUCK0_VOUT	BUCK0_VSET[7:0]	25h	800 mV
0x0C	BUCK1_VOUT	BUCK1_VSET[7:0]	25h	800 mV
0x0E	BUCK2_VOUT	BUCK2_VSET[7:0]	25h	800 mV
0x10	BUCK3_VOUT	BUCK3_VSET[7:0]	B1h	1800 mV
0x12	BUCK0_DELAY	BUCK0_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x12	BUCK0_DELAY	BUCK0_STARTUP_DELAY[3:0]	00h	0 ms
0x13	BUCK1_DELAY	BUCK1_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x13	BUCK1_DELAY	BUCK1_STARTUP_DELAY[3:0]	00h	0 ms
0x14	BUCK2_DELAY	BUCK2_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x14	BUCK2_DELAY	BUCK2_STARTUP_DELAY[3:0]	00h	0 ms
0x15	BUCK3_DELAY	BUCK3_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x15	BUCK3_DELAY	BUCK3_STARTUP_DELAY[3:0]	00h	0 ms
0x16	GPIO2_DELAY	GPIO2_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x16	GPIO2_DELAY	GPIO2_STARTUP_DELAY[3:0]	00h	0 ms
0x17	GPIO3_DELAY	GPIO3_SHUTDOWN_DELAY[3:0]	00h	0 ms
0x17	GPIO3_DELAY	GPIO3_STARTUP_DELAY[3:0]	00h	0 ms
0x19	CONFIG	DOUBLE_DELAY	00h	0-15 ms with 1 ms steps
0x19	CONFIG	CLKIN_PD	01h	Enabled
0x19	CONFIG	EN3_PD	01h	Enabled
0x19	CONFIG	TDIE_WARN_LEVEL	01h	137C
0x19	CONFIG	EN2_PD	01h	Enabled
0x19	CONFIG	EN1_PD	01h	Enabled
0x21	TOP_MASK1	SYNC_CLK_MASK	01h	Masked
0x21	TOP_MASK1	TDIE_WARN_MASK	00h	Unmasked
0x21	TOP_MASK1	I_LOAD_READY_MASK	01h	Masked
0x22	TOP_MASK2	RESET_REG_MASK	01h	Masked
0x23	BUCK_0_1_MASK	BUCK1_PG_MASK	01h	Masked
0x23	BUCK_0_1_MASK	BUCK1_ILIM_MASK	00h	Unmasked
0x23	BUCK_0_1_MASK	BUCK0_PG_MASK	01h	Masked
0x23	BUCK_0_1_MASK	BUCK0_ILIM_MASK	00h	Unmasked
0x24	BUCK_2_3_MASK	BUCK3_PG_MASK	01h	Masked
0x24	BUCK_2_3_MASK	BUCK3_ILIM_MASK	00h	Unmasked
0x24	BUCK_2_3_MASK	BUCK2_PG_MASK	01h	Masked
0x24	BUCK_2_3_MASK	BUCK2_ILIM_MASK	00h	Unmasked
0x28	PGOOD_CTRL1	PG3_SEL[1:0]	01h	Power-Good-threshold voltage
0x28	PGOOD_CTRL1	PG2_SEL[1:0]	00h	Masked
0x28	PGOOD_CTRL1	PG1_SEL[1:0]	00h	Masked
0x28	PGOOD_CTRL1	PG0_SEL[1:0]	01h	Power-Good-threshold voltage
0x29	PGOOD_CTRL2	HALF_DELAY	00h	0-15 ms with 1 ms steps
0x29	PGOOD_CTRL2	EN_PG0_NINT	00h	PGOOD signal NOT included to nINT signal
0x29	PGOOD_CTRL2	PGOOD_SET_DELAY	00h	4-10 us
0x29	PGOOD_CTRL2	EN_PGFLT_STAT	00h	Live status of monitored voltage outputs
0x29	PGOOD_CTRL2	PGOOD_WINDOW	01h	Overvoltage and undervoltage monitoring
0x29	PGOOD_CTRL2	PGOOD_OD	01h	Open-drain output
0x29	PGOOD_CTRL2	PGOOD_POL	00h	HIGH
0x2B	PLL_CTRL	PLL_MODE[1:0]	00h	PLL disabled, internal RC oscillator
0x2B	PLL_CTRL	EXT_CLK_FREQ[4:0]	01h	2 MHz
0x2C	PIN_FUNCTION	EN_SPREAD_SPEC	01h	Enabled
0x2C	PIN_FUNCTION	EN_PIN_CTRL_GPIO3	01h	GPIO3_OUT bit AND ENx pin
0x2C	PIN_FUNCTION	EN_PIN_SELECT_GPIO3	00h	GPIO3_SEL bit AND EN1 pin
0x2C	PIN_FUNCTION	EN_PIN_CTRL_GPIO2	01h	GPIO2_OUT bit AND ENx pin
0x2C	PIN_FUNCTION	EN_PIN_SELECT_GPIO2	00h	GPIO2_SEL bit AND EN1 pin
0x2C	PIN_FUNCTION	GPIO3_SEL	01h	GPIO3
0x2C	PIN_FUNCTION	GPIO2_SEL	00h	EN2
0x2C	PIN_FUNCTION	GPIO1_SEL	00h	EN1
0x2D	GPIO_CONFIG	GPIO3_OD	00h	Push-pull output
0x2D	GPIO_CONFIG	GPIO2_OD	01h	Open-drain output
0x2D	GPIO_CONFIG	GPIO1_OD	00h	Push-pull output
0x2D	GPIO_CONFIG	GPIO3_DIR	01h	Output
0x2D	GPIO_CONFIG	GPIO2_DIR	00h	Input
0x2D	GPIO_CONFIG	GPIO1_DIR	00h	Input
0x2F	GPIO_OUT	GPIO3_OUT	01h	Logic high level
0x2F	GPIO_OUT	GPIO2_OUT	01h	Logic high level