SPRUIT0A December 2019 – May 2020
-
Jacinto7 EVM Infotainment Expansion
- Trademarks
- 1 Introduction
- 2 Infotainment Expansion Board Overview
- 3 Infotainment Expansion Board - User Setup/Configuration
- 4
Infotainment Expansion Board Hardware Architecture
- 4.1 Infotainment Expansion Board Hardware Top Level Diagram
- 4.2 Expansion Connectors
- 4.3 Board ID EEPROM
- 4.4 Audio Codec Interface
- 4.5 FPD link De-Serializer Interface (Audio)
- 4.6 DIR Interface
- 4.7 DIT Interface
- 4.8 Legacy Audio/JAMR3 Connectors
- 4.9 VIN/VOUT Mux Selection
- 4.10 HDMI Interface Bridge
- 4.11 FPD Link Display Serializer Interface
- 4.12 Parallel Camera Interface
- A Jacinto7 EVM Interface/IO Mapping
- Revision History
4.9 VIN/VOUT Mux Selection
The multiplexed video Input/Output signals from Expansion connector connected to three 12 bit 1:3 De-muxer U10, U11 and U12 IC Mfr. Part# SN74CBT16214CDGGR. One channel (Port B1) of the de-muxer interfaced with HDMI transmitter, the second channel (Port B2) interfaced with parallel camera interface and the third channel (Port B3) interfaced with FPD display port on the infotainment expansion board. For Mux selection GPIO details, see Section A.2.
Figure 17. VIN/VOUT Mux Selection Table 10. VIN/VOUT Mux Selection Table
| Selection Inputs | Inputs/Outputs | Function |
|---|---|---|
| S2 S1 S0 | A1 | |
| H H L | VOUT | A1 port = B1 port (HDMI)- Default |
| H H H | VIN | A1 port = B2 port (Camera) |
| H L H | VOUT | A1 port = B3 port (FPD Link) |