SPRUJ15B November   2021  – October 2022

 

  1.   F2800137 controlCARD Information Guide
  2.   Trademarks
  3. 1Introduction
  4. 2Hardware Quick Setup Guide
    1. 2.1 Configuration 1: Standalone
    2. 2.2 Configuration 2: External 5 V Supply
  5. 3Errata
    1. 3.1 Warnings, Notes, and Errata
    2. 3.2 Warnings About Specific controlCARD Revisions
  6. 4Getting Familiar with the controlCARD
    1. 4.1 F2800137 controlCARD Features
    2. 4.2 Assumed Operating Conditions
    3. 4.3 Power Supply Requirements
      1. 4.3.1 External Power Supply or Accessory Requirements
    4. 4.4 Using the controlCARD
    5. 4.5 Experimentation Software
  7. 5Special Notes
    1. 5.1 XDS110 Emulator and SCI (UART) Connectivity
    2. 5.2 Clocking Methodology
    3. 5.3 Evaluation of the Analog-to-Digital Converters (ADCs)
  8. 6Hardware References
  9. 7Revision History

Warnings About Specific controlCARD Revisions

Table 3-1 MCU102A
Issue Description
5-V power supply instability can lead to device resetsSee Section 3.1 about power supply instability.

 

Table 3-2 MCU102E1
IssueDescription
Incorrect label on TP1TP1 is incorrectly labeled as 5V5 on the front side of the controlCARD PCB. TP1 corresponds to the HSEC_5V0 rail on the board.
5-V power supply instability can lead to device resetsSee Section 3.1 about power supply instability.
EVM for software development onlyThis EVM is for software development only and is meant to be used only with the TMDSHSECDOCK.