Observe the following for testing the TIEVM-MTR-HVINV :
- For input, the power supply source must range from 165-V to 265-V AC if using the AC source, or must range from 100 V to 400 V if using a DC power supply. Set the input current limit of input AC source to 10 A or DC power supply to 6.5 A.
- For the output, use a 3-phase PMSM with a dynamometer to apply counter-rotation.
For board testing, the HV-qualified engineer must use the following equipment:
- Isolated AC source
- 750-W maximum, 3-phase PMSM
The following equipment is also highly recommended for full testing, but is not necessarily required for basic operation:
- DC power supply
- Dynamometer
- Single-phase power analyzer
- Three-phase power analyzer
- Oscilloscope
- HV probes
- At least 1 current
probe
- Multimeter