SWAU085F July   2011  – January 2022

 

  1.   Trademarks
  2.   Revision History
  3. 1Requirements
    1. 1.1 System Requirements
    2. 1.2 Configuration Requirements
  4. 2Installation
  5. 3Modes of Operation
    1. 3.1 Serial Port Mode
    2. 3.2 USB Over Android Debug Bridge (ADB) Mode
    3. 3.3 Operational Mode
  6. 4Connection and Firmware Download
    1. 4.1 Register Reads and Writes
    2. 4.2 Power Mode Menu
      1. 4.2.1 Awake Mode
      2. 4.2.2 Listen Mode
      3. 4.2.3 ELP Mode
      4. 4.2.4 Gating Mode
    3. 4.3 Antenna Mode Menu
      1. 4.3.1 Supported Antenna Configuration
      2. 4.3.2 5-GHz Diversity (WL1837MOD and WL1807MOD Only)
  7. 5RX Tab
    1. 5.1 RX Statistics Area
    2. 5.2 Sensitivity Measurements
      1. 5.2.1 Sensitivity Testing Procedure
  8. 6TX Tab
    1. 6.1 TX Packets Section
    2. 6.2 TX Tab Overall Output Power Area
    3. 6.3 TX Tab Tones Area
    4. 6.4 TX Duty Cycle Configuration
    5. 6.5 Output Power Test on the WiLink 8 Device
      1. 6.5.1 TX Testing Procedure
  9. 7Terms and Abbreviations

Terms and Abbreviations

Table 7-1 lists terms and abbreviations.

Table 7-1 Terms and Abbreviations
Term Description
ADB Android debug bridge
BD_ADDR Bluetooth device address
BER Bit error rate
BT Bluetooth
BW Bandwidth
CW Carrier wave
DRPw Digital radio processor (wideband)
ELP Energy low power
FCS Frame check sequence
HCI Host controller interface
Host/host PC A PC connected to the device through the serial port
LMP Link manager protocol
LQM Link quality monitor
MAC Medium access control
MCU Microcontroller unit
MIMO Multiple input, multiple output
OSI Open Systems Interconnection model
PER Packet error rate
PHY Physical layer of the OSI model
PVT Process, voltage, temperature
RF Radio frequency
RSSI Received signal strength indication
RTTT WLAN Real-Time Tuning Tool
SDIO Secure digital input output
SGI Short guard interval
SISO Single input, single output
SW Software
SoC System-on-chip
VS Vendor-specific