5.1 Performance Parameters - Typical
- System design power scheme must comply with both peak and average TX bursts
- WLAN maximum VBAT current draw of 725 mA with MIMO continues burst configuration
- Peak current VBAT can hit 850 mA during device calibration (1)
| (1) |
- At wakeup, the WiLink™ 8 module performs the entire calibration sequence at the center of the 2.4-GHz band.
- Once a link is established, calibration is performed periodically (every 5 minutes) on the specific tuned channel.
- The maximum VBAT value is based on peak calibration consumption with a 30% margin.
|
|
|
For more information on WiLink8 current consumption and Max VBAT / VIO, see the WL18xxmod device-specific data sheet (http://www.ti.com/lsds/ti/wireless_connectivity/wilink/products.page).