SWRU439M October 2015 – April 2022
At the top of the Setup tab, select the project and the task to trigger code generation. The code generation event log is displayed only if there are any errors.
Select either the low-level or simplified workflow, and observe the state diagram that is displayed in the middle of the Setup tab.
At the bottom of the Setup tab, specify a sequence of actions to be performed for each task iteration. Enter "Run Execution Code" for the ADC Window Monitor example.
Each task code block in the action sequence runs at full speed. However, for most iteration actions, there is need for handshaking or data transfer over JTAG, which means that the task will not execute with the same timing during task testing as it will in the actual application.