5.5.4 Compiling and Debugging the Project in IAR

For the debug session, complete the following steps:

1. Select Project → options from the menu, and select the Debugger category. In the Setup tab, choose TI XDS as the driver and click OK (see Figure 30).
Figure 30. IAR TI XDS Debugger
2. Go to the TI XDS category, choose TI XDS110 Emulator as the emulator and JTAG (4-pin) as the interface (see Figure 31).
Figure 31. IAR XDS110 Debugger
3. Check the Use flash loader(s) checkbox in the Debugger → Download tab (see Figure 32).
Figure 32. IAR Debugger Settings
4. Start debugging by clicking the green arrow on the top of the window to start the debugger.