Revisions Affected:

Revision C

Details:

For the conditions given below, the device will boot into and execute the ROM serial bootloader when waking up from Shutdown power mode. Intended behavior is to execute the application image. The prerequisites for this erratum to happen are:

• The wake up from Shutdown must be caused by toggling or noise on the JTAG TCK pin and not by a GPIO event.
• The Customer Configuration Section (CCFG) must have configured the bootloader with the following field values:
  • BOOTLOADER_ENABLE = 0xC5 (Bootloader enabled)
  • BL_ENABLE = 0xC5 (Bootloader pin backdoor enabled)
  • BL_PIN_NUMBER = n (any valid DIO number)

With the above prerequisites, the bootloader will be entered in the following cases:

• The CCFG bootloader pin level (BL_LEVEL) is set to 0x0 (active low) AND the input buffer enable for the DIO defined in BL_PIN_NUMBER is disabled in register IOC.IOCFGn.IE. If the input buffer is not enabled, the DIO level will always read 0 and bootloader will be entered.
• The input buffer is controlled by IOC.IOCFGn.IE is enabled and the DIO input value is the same level as the CCFG bootloader pin level (BL_LEVEL) when entering Shutdown (GPIO input values are latched when entering Shutdown).

Please refer to the ICEMelter chapter in CC13x4x10, CC26x4x10 SimpleLink™ Wireless MCU TRM for details on how noise entering the JTAG TCK pin can wake up the device.

Workarounds:

One of the following workarounds must be implemented:

• If the input buffer is not enabled, use only the active high bootloader pin level (BL_LEVEL).
• If input buffer is enabled, ensure DIO input pin level is not the same as bootloader pin level (BL_LEVEL) when entering Shutdown.