typical values at TA =
25°C, VA19 = 1.9 V, VA11 = VD11 = 1.1 V, default full-scale voltage (FS_RANGE_A =
FS_RANGE_B = 0xA000), input signal applied to INA± in single-channel modes,
fIN = 347 MHz, AIN = –1 dBFS, fCLK =
maximum-rated clock frequency, filtered, 1-VPP sine-wave clock, JMODE =
1, dither enabled with default settings, VA11, VD11 and VS11 noise suppression ON
(EN_VA11_NOISE_SUPPR = EN_VD11_NOISE_SUPPR = EN_VS11_NOISE_SUPPR = 1), and background calibration (unless otherwise
noted); SNR results exclude DC, HD2 to HD9 and interleaving spurs; SINAD, ENOB, and
SFDR results exclude DC and fixed-frequency interleaving spurs
Figure 5-1 Input
Amplitude vs Input Frequency
Figure 5-3 DNL
vs ADC Code
Figure 5-5 DES
Mode: Single Tone FFT at 347 MHz
Figure 5-7 DES
Mode: Single Tone FFT at 2397 MHz
Figure 5-9 DES
Mode: Single Tone FFT at 5597 MHz
| each
tone at -7 dBFS, 100MHz Tone Spacing |
Figure 5-11 DES
Mode: Two Tone FFT at 347 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-13 DES
Mode: Two Tone FFT at 2397 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-15 DES
Mode: Two Tone FFT at 5597 MHz
Figure 5-17 Dual
Channel Mode: Single Tone FFT at 347 MHz
Figure 5-19 Dual
Channel Mode: Single Tone FFT at 2397 MHz
Figure 5-21 Dual
Channel Mode: Single Tone FFT at 5597 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-23 Dual
Channel Mode: Two Tone FFT at 347 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-25 Dual
Channel Mode: Two Tone FFT at 2397 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-27 Dual
Channel Mode: Two Tone FFT at 5597 MHz
Figure 5-29 DES
Mode: SNR vs Sample Rate and Input Frequency
Figure 5-31 DES
Mode: SNR vs Sample Rate and Input Frequency
Figure 5-33 DES
Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-35 DES
Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-37 DES
Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-39 DES
Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-41 DES
Mode: Fs/2 - FIN vs Sample Rate and Input Frequency
Figure 5-43 DES
Mode: Fs/4 - FIN vs Sample Rate and Input Frequency
Figure 5-45 Dual
Channel Mode: SNR vs Sample Rate and Input Frequency
Figure 5-47 Dual
Channel Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-49 Dual
Channel Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-51 Dual
Channel Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-53 Dual
Channel Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-55 Dual
Channel Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-57 DES
Mode: SNR vs Input Amplitude and Frequency
Figure 5-59 DES
Mode: SFDR vs Input Amplitude and Frequency
Figure 5-61 DES
Mode: HD2 vs Input Amplitude and Frequency
Figure 5-63 DES
Mode: HD3 vs Input Amplitude and Frequency
Figure 5-65 DES
Mode: Fs/2 - FIN vs Input Amplitude and Frequency
Figure 5-67 DES
Mode: Fs/4 + FIN vs Input Amplitude and Frequency
Figure 5-69 DES
Mode: Fs/4 - FIN vs Input Amplitude and Frequency
Figure 5-71 Dual
Channel Mode: SNR vs Input Amplitude and Frequency
Figure 5-73 Dual
Channel Mode: SFDR vs Input Amplitude and Frequency
Figure 5-75 Dual
Channel Mode: HD2 vs Input Amplitude and Frequency
Figure 5-77 Dual
Channel Mode: HD3 vs Input Amplitude and Frequency
Figure 5-79 Dual
Channel Mode: Fs/2 - FIN vs Input Amplitude and Frequency
Figure 5-81 DES
Mode: SNR vs Clock Amplitude
Figure 5-83 Dual
Channel Mode: SNR vs Clock Amplitude
| FG
calibration at each temperature |
Figure 5-85 DES
Mode: SNR, SINAD and SFDR vs Temperature
| FG
calibration at each temperature |
Figure 5-87 DES
Mode: HD2, HD3 and Worst non-HD Spur vs Temperature
| FG
calibration at each temperature |
Figure 5-89 Dual
Channel Mode: SNR, SINAD and SFDR vs Temperature
| FG
calibration at each temperature |
Figure 5-91 Dual
Channel Mode: HD2, HD3 and Worst non-HD Spur vs Temperature
| All
supplies varied together |
Figure 5-93 DES
Mode: SNR, SINAD and SFDR vs Supply Voltage
| All
supplies varied together |
Figure 5-95 Dual
Channel Mode: SNR, SINAD and SFDR vs Supply Voltage
Figure 5-97 SNR,
SFDR and SINAD vs Input Common Mode Voltage
Figure 5-99 DES
Mode: IMD3 vs Input Frequency
Figure 5-101 DES
Mode: IMD3 vs Tone Spacing
Figure 5-103 DES
Mode: Two Tone SFDR vs Input Amplitude
Figure 5-105 Dual
Chanel Mode: IMD3 vs Input Amplitude
Figure 5-107 Dual
Chanel Mode: Two Tone SFDR vs Input Frequency
| Dual
channel mode, JMODE 3 |
Figure 5-2 Crosstalk vs Input Frequency
Figure 5-4 INL
vs ADC Code
Figure 5-6 DES
Mode: Single Tone FFT at 897 MHz
Figure 5-8 DES
Mode: Single Tone FFT at 4197 MHz
Figure 5-10 DES
Mode: Single Tone FFT at 7997 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-12 DES
Mode: Two Tone FFT at 897 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-14 DES
Mode: Two Tone FFT at 4197 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-16 DES
Mode: Two Tone FFT at 7997 MHz
Figure 5-18 Dual
Channel Mode: Single Tone FFT at 897 MHz
Figure 5-20 Dual
Channel Mode: Single Tone FFT at 4197 MHz
Figure 5-22 Dual
Channel Mode: Single Tone FFT at 7997 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-24 Dual
Channel Mode: Two Tone FFT at 897 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-26 Dual
Channel Mode: Two Tone FFT at 4197 MHz
| each
tone at -7 dBFS, 100 MHz Tone Spacing |
Figure 5-28 Dual
Channel Mode: Two Tone FFT at 7997 MHz
Figure 5-30 DES
Mode: SNR vs Sample Rate and Input Frequency
Figure 5-32 DES
Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-34 DES
Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-36 DES
Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-38 DES
Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-40 DES
Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-42 DES
Mode: Fs/4 + FIN vs Sample Rate and Input Frequency
Figure 5-44 Dual
Channel Mode: SNR vs Sample Rate and Input Frequency
Figure 5-46 Dual
Channel Mode: SNR vs Sample Rate and Input Frequency
Figure 5-48 Dual
Channel Mode: SFDR vs Sample Rate and Input Frequency
Figure 5-50 Dual
Channel Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-52 Dual
Channel Mode: HD2 vs Sample Rate and Input Frequency
Figure 5-54 Dual
Channel Mode: HD3 vs Sample Rate and Input Frequency
Figure 5-56 Dual
Channel Mode: Fs/2 - FIN vs Sample Rate and Input
Frequency
Figure 5-58 DES
Mode: SNR vs Input Amplitude and Dither
Figure 5-60 DES
Mode: SFDR vs Input Amplitude and Dither
Figure 5-62 DES
Mode: HD2 vs Input Amplitude and Dither
Figure 5-64 DES
Mode: HD3 vs Input Amplitude and Dither
Figure 5-66 DES
Mode: Fs/2 - FIN vs Input Amplitude and DitherFigure 5-68 DES
Mode: Fs/4 + FIN vs Input Amplitude and Dither 
Figure 5-70 DES
Mode: Fs/4 - FIN vs Input Amplitude and Dither
Figure 5-72 Dual
Channel Mode: SNR vs Input Amplitude and Dither
Figure 5-74 Dual
Channel Mode: SFDR vs Input Amplitude and Dither
Figure 5-76 Dual
Channel Mode: HD2 vs Input Amplitude and Dither
Figure 5-78 Dual
Channel Mode: HD3 vs Input Amplitude and Dither
Figure 5-80 Dual
Channel Mode: Fs/2 - FIN vs Input Amplitude and Dither
Figure 5-82 DES
Mode: SFDR vs Clock Amplitude
Figure 5-84 Dual
Channel Mode: SFDR vs Clock Amplitude
| FG25
is calibrated at 25°C and held at other temperatures,
other modes recalibrated at each temperature |
Figure 5-86 DES
Mode: SNR vs Temperature and Calibration Mode
| FG25
is calibrated at 25°C and held at other temperatures,
other modes recalibrated at each temperature |
Figure 5-88 DES
Mode: SFDR vs Temperature and Calibration Mode
| FG25
is calibrated at 25°C and held at other temperatures,
other modes recalibrated at each temperature |
Figure 5-90 Dual
Channel Mode: SNR vs Temperature and Calibration Mode
| FG25
is calibrated at 25°C and held at other temperatures,
other modes recalibrated at each temperature |
Figure 5-92 Dual
Channel Mode: SFDR vs Temperature and Calibration Mode
| All
supplies varied together |
Figure 5-94 DES
Mode: HD2, HD3 and Worst non-HD Spur vs Supply Voltage
| All
supplies varied together |
Figure 5-96 Dual
Channel Mode: HD2, HD3 and Worst non-HD Spur vs Supply Voltage
Figure 5-98 Fs/2
- FIN and Fs/4 ± FIN vs Input Common Mode
Voltage
Figure 5-100 DES
Mode: IMD3 vs Input Amplitude
Figure 5-102 DES
Mode: Two Tone SFDR vs Input Frequency
Figure 5-104 Dual
Chanel Mode: IMD3 vs Input Frequency
Figure 5-106 Dual
Chanel Mode: IMD3 vs Tone Spacing
Figure 5-108 Dual
Chanel Mode: Two Tone SFDR vs Input Amplitude
Figure 5-121 DES
Mode: IVA19 vs Sample Rate
Figure 5-123 DES
Mode: IVD11 vs Sample Rate
Figure 5-125 DES
Mode: IVD11 vs Sample Rate
Figure 5-127 DES
Mode: Power Dissipation vs Sample Rate
Figure 5-129 DES
Mode: Power Dissipation vs Sample Rate
Figure 5-131 Dual
Channel Mode: IVA19 vs Sample Rate
Figure 5-133 Dual
Channel Mode: IVD11 vs Sample Rate
Figure 5-135 Dual
Channel Mode: IVD11 vs Sample Rate
Figure 5-137 Dual
Channel Mode: Power Dissipation vs Sample Rate
Figure 5-139 Dual
Channel Mode: Power Dissipation vs Sample Rate
Figure 5-141 Power
Dissipation vs Temperature
Figure 5-143 Background Calibration Core Transition (AC Signal - zoomed)
Figure 5-145 Background Calibration Core Transition (DC Signal - zoomed)
Figure 5-147 Pulse
Overdrive Recovery Zoomed
Figure 5-149 Sinewave Overdrive Recovery
Figure 5-122 DES
Mode: IVA11 vs Sample Rate
Figure 5-124 DES
Mode: IVD11 vs Sample Rate
Figure 5-126 DES
Mode: IVD11 vs Sample Rate
Figure 5-128 DES
Mode: Power Dissipation vs Sample Rate
Figure 5-130 DES
Mode: Power Dissipation vs Sample Rate
Figure 5-132 Dual
Channel Mode: IVA11 vs Sample Rate
Figure 5-134 Dual
Channel Mode: IVD11 vs Sample Rate
Figure 5-136 Dual
Channel Mode: IVD11 vs Sample Rate
Figure 5-138 Dual
Channel Mode: Power Dissipation vs Sample Rate
Figure 5-140 Dual
Channel Mode: Power Dissipation vs Sample Rate
Figure 5-142 Background Calibration Core Transition (AC Signal)
Figure 5-144 Background Calibration Core Transition (DC Signal)
Figure 5-146 Pulse
Overdrive Recovery
Figure 5-148 Sinewave Overdrive Recovery
