ZHCSIP2E April   2016  – October 2018 LMG3410R070 , LMG3411R070

PRODUCTION DATA.  

  1. 1 特性
  2. 2 应用
  3. 3 说明
    1.     Device Images
      1.      简化方框图
      2.      高于 100V/ns 时的开关性能
  4. 4 修订历史记录
  5. 5 Pin Configuration and Functions
    1.     Pin Functions
  6. 6 Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 ESD Ratings
    3. 6.3 Recommended Operating Conditions
    4. 6.4 Thermal Information
    5. 6.5 Electrical Characteristics
    6. 6.6 Switching Characteristics
    7. 6.7 Typical Characteristics
  7. 7 Parameter Measurement Information
    1. 7.1 Switching Parameters
      1. 7.1.1 Turn-on Delays
      2. 7.1.2 Turn-off Delays
      3. 7.1.3 Drain Slew Rate
      4. 7.1.4 Turn-on and Turn-off Energy
  8. 8 Detailed Description
    1. 8.1 Overview
    2. 8.2 Functional Block Diagram
    3. 8.3 Feature Description
      1. 8.3.1 Direct-Drive GaN Architecture
      2. 8.3.2 Internal Buck-Boost DC-DC Converter
      3. 8.3.3 Internal Auxiliary LDO
      4. 8.3.4 Fault Detection
        1. 8.3.4.1 Over-current Protection
        2. 8.3.4.2 Over-Temperature Protection and UVLO
      5. 8.3.5 Drive Strength Adjustment
    4. 8.4 Device Functional Modes
      1. 8.4.1 Low-Power Mode
  9. 9 Application and Implementation
    1. 9.1 Application Information
    2. 9.2 Typical Application
      1. 9.2.1 Design Requirements
      2. 9.2.2 Detailed Design Procedure
        1. 9.2.2.1 Slew Rate Selection
          1. 9.2.2.1.1 Startup and Slew Rate with Bootstrap High-Side Supply
        2. 9.2.2.2 Signal Level-Shifting
        3. 9.2.2.3 Buck-Boost Converter Design
      3. 9.2.3 Application Curves
    3. 9.3 Paralleling GaN Devices
    4. 9.4 Do's and Don'ts
  10. 10Power Supply Recommendations
    1. 10.1 Using an Isolated Power Supply
    2. 10.2 Using a Bootstrap Diode
      1. 10.2.1 Diode Selection
      2. 10.2.2 Managing the Bootstrap Voltage
      3. 10.2.3 Reliable Bootstrap Start-up
  11. 11Layout
    1. 11.1 Layout Guidelines
      1. 11.1.1 Power Loop Inductance
      2. 11.1.2 Signal Ground Connection
      3. 11.1.3 Bypass Capacitors
      4. 11.1.4 Switch-Node Capacitance
      5. 11.1.5 Signal Integrity
      6. 11.1.6 High-Voltage Spacing
      7. 11.1.7 Thermal Recommendations
    2. 11.2 Layout Example
  12. 12器件和文档支持
    1. 12.1 器件支持
      1. 12.1.1 第三方米6体育平台手机版_好二三四免责声明
    2. 12.2 文档支持
      1. 12.2.1 相关文档
    3. 12.3 接收文档更新通知
    4. 12.4 社区资源
    5. 12.5 商标
    6. 12.6 静电放电警告
    7. 12.7 术语表
  13. 13机械、封装和可订购信息

6.5 Electrical Characteristics

over operating free-air temperature range, 9.5 V < VDD < 18 V, LPM = 5 V, VNEG = -14 V (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
GaN POWER
TRANSISTOR
RDS,ON On-state Resistance TJ = 25°C 70 mΩ
TJ = 125°C 110
VSD Third-quadrant mode source-drain voltage IN = 0 V, ISD = 0.1 A 5 V
IN = 0 V, ISD = 10 A 7.8
IDSS Drain Leakage Current VDS = 600 V, TJ = 25°C 1 5 µA
VDS = 600 V, TJ = 125°C 10
Coss GaN output capacitance IN = 0 V, VDS = 400 V, fSW = 250 kHz 71 pF
Coss,er Effective output capacitance, energy related IN = 0 V, VDS =0-400 V 95 pF
Coss,tr Effective output capacitance, time related ID = 5 A, IN = 0 V, VDS = 0-400 V 145 pF
Qrr Reverse recovery charge VR = 400 V, ISD = 5 A, dISD/dt = 1 A/ns 0 nC
DRIVER SUPPLY
IVDD,LPM Quiescent current, ultra-low-power mode VLPM = 0 V, VDD = 12 V 80 95 µA
IVDD,Q Quiescent current (average) Transistor held off 0.5 mA
transistor held on 0.5
IVDD,op Operating current VDD = 12 V, fSW = 1 MHz, RDRV=40 kΩ, 50% duty cycle 43 mA
V+5V 5V LDO output voltage VDD = 12 V 4.7 5.3 V
VNEG Negative Supply 30-mA load current -13.9 V
BUCK BOOST
CONVERTER
fSW,GAN FET switching frequency 1 MHz
IDCDC,PK Peak inductor current IOUT = 20 mA, VIN = 12 V, VOUT = -14 V 250 350 mA
ΔVNEG DC-DC output ripple voltage, pk-pk CNEG = 2.2 µF, IOUT = 20 mA 50 mV
DRIVER INPUT
VIH Input pin, LPM pin, logic high threshold 2.5 V
VIL Input pin, LPM pin, low threshold 0.8 V
VHYST Input pin, LPM pin, hysteresis 0.8 V
RIN,L Input pull-down resistance 150 kΩ
RLPM LPM pin pull-down resistance 150 kΩ
UNDERVOLTAGE LOCKOUT
VDD,(ON) VDD turnon threshold Turn-on voltage 9.1 V
VDD,(OFF) VDD turnoff threshold Turn-off voltage 8.5 V
ΔVDD,UVLO UVLO Hysteresis 550 mV
FAULT
Itrip Current Fault Trip Point 22 36 50 A
Ttrip Temperature Trip Point trip point 165 °C
TtripHys Temperature Trip Hysteresis 20 °C
千亿体育app官网登录(中国)官方网站IOS/安卓通用版/手机APP | 米乐app下载官网（中国）|ios|Android/通用版APP最新版 | 米乐|米乐·M6（中国大陆）官方网站 | 千亿体育登陆地址 | 华体会体育（中国）HTH·官方网站 | 千赢qy国际_全站最新版千赢qy国际V6.2.14安卓/IOS下载 | 18新利网v1.2.5|中国官方网站 | bob电竞真人（中国官网）安卓/ios苹果/电脑版【1.97.95版下载】 | 千亿体育app官方下载(中国)官方网站IOS/安卓/手机APP下载安装 |