8 Parameter Measurement Information

Figure 8-1 Test System: Operating Voltage Range with RX and TX Access: Parameters 9, 10

Figure 8-2 RX Response: Operating Voltage Range

Figure 8-3 LIN Bus Input Signal

Figure 8-4 LIN Receiver Test with RX access Param 17, 18, 19, 20

Figure 8-5 V_{SUP_NON_OP} Param 1154/56

Figure 8-6 Test Circuit for I_{BUS_LIM} at Dominant State (Driver on) Param 12

Figure 8-7 Test Circuit for I_{BUS_PAS_dom}; TXD = Recessive State V_BUS = 0 V, Param 13

Figure 8-8 Test Circuit for I_{BUS_PAS_rec} Param 14

Figure 8-9 Test Circuit for I_{BUS_NO_GND} Loss of GND

Figure 8-10 Test Circuit Slope Control and Duty Cycle Param 27, 28, 29, 30, 72, 73, 74, 75

Figure 8-11 Definition of Bus Timing Parameters

Figure 8-12 Propagation Delay Test Circuit; Param 31, 32

Figure 8-13 Propagation Delay

Figure 8-14 Mode Transitions

Figure 8-15 Wake-up Through EN

Figure 8-16 Wake-up through LIN