Do

• Good decoupling between VCC and GND, minimize the loop of VCC-GND and the decoupling capacitor
• Use transformer with split chamber bobbin to minimize the EMI noise coupling from the inverter power stage
• The UCC25800-Q1 transformer driver can be used to drive single higher power transformer or multiple lower power transformer
• Setting the OCP1 level according to the designed load
• Use post regulator if the voltage regulation requirement can't be met
• Add Zener clamp at output if the output load can be completely removed
• If cost is acceptable, use NP0 or C0G type resonant capacitor, or use X7R with much higher voltage rating than needed
• Sufficient copper area for thermal management if the ambient temperature is high or the power level is high

Not to Do

• Long VCC-GND decoupling capacitor trace
• Set up the OCP1 to the highest level for all designs