ZHCSOR0 August   2021 TPS25868-Q1 , TPS25869-Q1

PRODUCTION DATA  

  1. 1 特性
  2. 2 应用
  3. 3 说明
  4. 4 Revision History
  5. 5 说明（续）
  6. 6 Device Comparison Table
  7. 7 Pin Configuration and Functions
  8. 8 Specifications
    1. 8.1 Absolute Maximum Ratings
    2. 8.2 ESD Ratings
    3. 8.3 Recommended Operating Conditions
    4. 8.4 Thermal Information
    5. 8.5 Electrical Characteristics
    6. 8.6 Timing Requirements
    7. 8.7 Switching Characteristics
    8. 8.8 Typical Characteristics
  9. 9 Parameter Measurement Information
  10. 10Detailed Description
    1. 10.1 Overview
    2. 10.2 Functional Block Diagram
    3. 10.3 Feature Description
      1. 10.3.1  Power-Down or Undervoltage Lockout
      2. 10.3.2  Input Overvoltage Protection (OVP) - Continuously Monitored
      3. 10.3.3  Buck Converter
      4. 10.3.4  FREQ/SYNC
      5. 10.3.5  Bootstrap Voltage (BOOT)
      6. 10.3.6  Minimum ON-Time, Minimum OFF-Time
      7. 10.3.7  Internal Compensation
      8. 10.3.8  Selectable Output Voltage (VSET)
      9. 10.3.9  Current Limit and Short Circuit Protection
        1. 10.3.9.1 USB Switch Programmable Current Limit (ILIM)
        2. 10.3.9.2 Interlocking for Two-Level USB Switch Current Limit
        3. 10.3.9.3 Cycle-by-Cycle Buck Current Limit
        4. 10.3.9.4 OUT Current Limit
      10. 10.3.10 Cable Compensation
      11. 10.3.11 Thermal Management with Temperature Sensing (TS) and OTSD
      12. 10.3.12 Thermal Shutdown
      13. 10.3.13 USB Enable On/Off Control (TPS25869-Q1)
      14. 10.3.14 FAULT Indication
      15. 10.3.15 USB Specification Overview
      16. 10.3.16 USB Type-C® Basics
        1. 10.3.16.1 Configuration Channel
        2. 10.3.16.2 Detecting a Connection
      17. 10.3.17 USB Port Operating Modes
        1. 10.3.17.1 USB Type-C® Mode
        2. 10.3.17.2 Dedicated Charging Port (DCP) Mode (TPS25868-Q1 Only)
          1. 10.3.17.2.1 DCP BC1.2 and YD/T 1591-2009
          2. 10.3.17.2.2 DCP Divider-Charging Scheme
          3. 10.3.17.2.3 DCP 1.2-V Charging Scheme
        3. 10.3.17.3 DCP Auto Mode (TPS25868-Q1)
    4. 10.4 Device Functional Modes
      1. 10.4.1 Shutdown Mode
      2. 10.4.2 Active Mode
  11. 11Application and Implementation
    1. 11.1 Application Information
    2. 11.2 Typical Applications
      1. 11.2.1 Design Requirements
      2. 11.2.2 Detailed Design Procedure
        1. 11.2.2.1 Output Voltage Setting
        2. 11.2.2.2 Switching Frequency
        3. 11.2.2.3 Inductor Selection
        4. 11.2.2.4 Output Capacitor Selection
        5. 11.2.2.5 Input Capacitor Selection
        6. 11.2.2.6 Bootstrap Capacitor Selection
        7. 11.2.2.7 Undervoltage Lockout Set-Point
        8. 11.2.2.8 Cable Compensation Set-Point
        9. 11.2.2.9 FAULT Resistor Selection
      3. 11.2.3 Application Curves
  12. 12Power Supply Recommendations
  13. 13Layout
    1. 13.1 Layout Guidelines
    2. 13.2 Layout Example
    3. 13.3 Ground Plane and Thermal Considerations
  14. 14Device and Documentation Support
    1. 14.1 接收文档更新通知
    2. 14.2 支持资源
    3. 14.3 Trademarks
    4. 14.4 Electrostatic Discharge Caution
    5. 14.5 术语表
  15. 15Mechanical, Packaging, and Orderable Information

11.2.3 Application Curves

Unless otherwise specified the following conditions apply: VIN = 13.5 V, fSW = 400 kHz, L = 3.3 µH, CSENSE = 141 µF, CPA_BUS = 1 µF, CPB_BUS = 1 µF, ILIM = GND, TA = 25 °C.
Unless otherwise specified the following conditions apply: VIN = 13.5 V, fSW = 400 kHz, L = 3.3 µH, CSENSE = 141 µF, CPA_BUS = 1 µF, CPB_BUS = 1 µF, ILIM = GND, TA = 25 °C.GUID-C7E421FA-5DEF-471E-B437-F7A65265A93E-low.gif
VSET = GND fSW = 400 kHz L = 3.3 uH
Figure 11-3 Buck Only Efficiency. Unless otherwise specified the following conditions apply: VIN = 13.5 V, fSW = 400 kHz, L = 3.3 µH, CSENSE = 141 µF, CPA_BUS = 1 µF, CPB_BUS = 1 µF, ILIM = GND, TA = 25 °C.
GUID-BAD17D2F-8D3E-4A93-B3E5-6DB91ED7972F-low.gif
VSET = GND fSW = 400 kHz
Figure 11-5 Load Regulation
GUID-20201102-CA0I-SXLK-35G0-V62TV2BTCJ6K-low.gif
VSET = VSENSE IPA_BUS = 0 A to 3 A IPB_BUS = 2.4 A fSW = 400 kHZ
Figure 11-7 Load Transient Without Cable Compensation
GUID-20201102-CA0I-MG4H-GM2X-KJMBQ0DQ3FLG-low.gif
VSET = VSENSE IPA_BUS = 0.75 A to 2.25 A IPB_BUS = 0 A fSW = 400 kHZ
Figure 11-9 Load Transient Without Cable Compensation
GUID-20201102-CA0I-PDKW-KZHW-9V82P69CDW8W-low.gif
VSET = GND IPB_BUS = 0.75 A to 2.25 A IPA_BUS = 0 A fSW = 400 kHZ
Figure 11-11 Load Transient With Cable Compensation
GUID-20201102-CA0I-ZNLB-HCPT-02TXJ5PJN86F-low.gif
VSET = GND IPA_BUS = 3 A IPB_BUS = 2.4 A fSW = 400 kHZ
Figure 11-13 6-A Output Ripple
GUID-20201102-CA0I-WQ1F-MCBQ-LN62RSP5QPWR-low.gif
VSET = GND IPA_BUS = 0 A IPB_BUS = 0 A fSW = 400 kHZ
Figure 11-15 No Load Output Ripple
GUID-5C4DEBA5-FEAB-41F4-8F4A-C80C074357D4-low.gif
VIN = 13.5 V to 0 V PA_CC1 = Rd IPA_BUS = 3 A
Figure 11-17 Shutdown Relate to VIN
GUID-7F3157D0-36FD-4A61-B764-EA51CE707879-low.gif
EN = 5 V to 0 V IPB_BUS = 2.4 A
Figure 11-19 Shutdown Relate to EN
GUID-7E7615E6-9FD6-4357-B971-373FDD0478E3-low.gif
PA_CC1 = Rd to Open PA_CC2 = Open IPA_BUS = 3 A
Figure 11-21 Rd Desert
GUID-28BC8CE0-D966-4C29-9FE0-FD7B584D44E1-low.gifFigure 11-23 Short Circuit Recovery
GUID-20201102-CA0I-XNPM-LQD8-2MSSZS17CG8N-low.gifFigure 11-25 1-Ω Load Recovery
GUID-F26E95A2-4230-4728-BE59-FF1036C42FDF-low.gif
PA_CC1 = Rd PA_CC2 = Ra
Figure 11-27 PA_CC2 Hot Short to GND
GUID-2BE121CC-E187-4F76-A8B0-2706DF625C5A-low.gif
PA_CC1 = Rd OUT = GND PA/B_BUS NO LOAD
Figure 11-29 OUT Hot Short to GND
GUID-9E9F85CB-CDB1-4C5E-BB4E-9008EC096398-low.gif
VTS = 0 V to 4 V PA_CC1 = Rd PA_CC2 = OPEN
Figure 11-31 Thermal Sensing - NTC Temperature HOT Behavior
GUID-20210315-CA0I-MLSH-X6D0-RV9K45BV3N3S-low.gif
Load = 6 A fSW = 400 kHz L = 3.3 uH
Figure 11-4 400-khz EMI Results (Without CM Filter)
GUID-1EF2B722-2182-4B59-9B29-D08BC2B4B09D-low.gif
VSET = GND fSW = 400 kHz
Figure 11-6 Line Regulation
GUID-F410F0F3-DC66-44E8-8023-6B2380249266-low.png
VSET = VSENSE IPB_BUS = 0 A to 2.4 A IPA_BUS = 3 A fSW = 400 kHZ
Figure 11-8 Load Transient Without Cable Compensation
GUID-11B96E3F-720E-4C20-9653-C8C2913A32A1-low.png
VSET = GND IPB_BUS = 0 A to 2.4 A IPA_BUS = 3 A fSW = 400 kHZ
Figure 11-10 Load Transient With Cable Compensation
GUID-3D8D678C-717C-4172-9A5C-F75D73E4ECDF-low.gifFigure 11-12 Dropout Characteristic
GUID-20201102-CA0I-79NM-SRM5-47NV1KJZND8K-low.gif
VSET = GND IPA_BUS = 0.1 A IPB_BUS = 0 A fSW = 400 kHZ
Figure 11-14 100-mA Output Ripple
GUID-B0880FC2-93C4-443C-85D0-7D571EC1136B-low.gif
VIN = 0 V to 13.5 V PA_CC1 = Rd IPA_BUS = 3 A
Figure 11-16 Startup Relate to VIN
GUID-6F927A0A-E7CE-4274-AB56-68363FBF1E30-low.gif
EN = 0 V to 5 V IPB_BUS = 2.4 A
Figure 11-18 Startup Relate to EN
GUID-4845565F-1E7E-47FB-8008-751E12D868FC-low.gif
PA_CC1 = Open to Rd PA_CC2 = Open IPA_BUS = 3 A
Figure 11-20 Rd Assert
GUID-0520CFF3-A5CF-4E4D-90DB-5504F5DC1B24-low.gif
EN to High PA_BUS = GND PB_BUS = GND
Figure 11-22 Enable Into Short
GUID-20201102-CA0I-ZRHT-DL73-FZNKWG8GGG1G-low.gif
EN to High PA_BUS = 1 Ω PB_BUS = 1 Ω
Figure 11-24 Enable Into 1-Ω Load
GUID-3FAD6F4D-86A7-417A-8838-A7D3589A49D1-low.gifFigure 11-26 VBUS Hot Short to GND
GUID-20024563-126B-41E9-8A98-D572E4933D27-low.gif
PA_CC1 = Rd OUT = 5.1 Ω PA/B_BUS NO LOAD
Figure 11-28 OUT short to 5.1-Ω Load
GUID-E4D4C289-B9A5-4060-9FE2-894BB36452B0-low.gif
VTS = 0 V to 2.6 V PA_CC1 = Rd PA_CC2 = OPEN
Figure 11-30 Thermal Sensing - NTC Temperature WARM Behavior
千亿体育app官网登录(中国)官方网站IOS/安卓通用版/手机APP | 米乐app下载官网（中国）|ios|Android/通用版APP最新版 | 米乐|米乐·M6（中国大陆）官方网站 | 千亿体育登陆地址 | 华体会体育（中国）HTH·官方网站 | 千赢qy国际_全站最新版千赢qy国际V6.2.14安卓/IOS下载 | 18新利网v1.2.5|中国官方网站 | bob电竞真人（中国官网）安卓/ios苹果/电脑版【1.97.95版下载】 | 千亿体育app官方下载(中国)官方网站IOS/安卓/手机APP下载安装 |