米6体育平台手机版

ZHCU737A June 2016 – May 2019 TPS3828

修订历史记录

5.1 Test Setup

To run the Hybrid RF/PLC test, a LAUNCHXL-CC1310 and TMDSPLCKITV4-CEN is required. Both EVMs are available in the TI store at TI.com.

Table 2 lists the required tools and software to run the hybrid wireless M-Bus/PLC test.

Table 2. Tools for Hybrid Wireless M-Bus/PLC Test Setup

DEVICE	EVM	HARDWARE MODIFICATION	FLASH FIRMWARE	GUI TOOL
Wireless M-Bus only	LAUNCXL-CC1310	No	Yes⁽¹⁾	No (Running as stand alone mode)
PLC only	TMDSPLCKITV4-CEN	No	Yes (Section 4.3.2)	Yes (Zero-configuration GUI) ⁽²⁾
Hybrid wireless M-Bus with PLC	CC1310DK TMDSPLCKITV4-CEN	No	Yes (Section 4.3.1)	No (Running as stand alone mode)

DEVICE

EVM

HARDWARE MODIFICATION

FLASH FIRMWARE

GUI TOOL

Wireless M-Bus only

LAUNCXL-CC1310

Yes⁽¹⁾

No (Running as stand alone mode)

PLC only

TMDSPLCKITV4-CEN

Yes (Section 4.3.2)

Yes (Zero-configuration GUI) ⁽²⁾

Hybrid wireless M-Bus with PLC

CC1310DK

TMDSPLCKITV4-CEN

Yes (Section 4.3.1)

No (Running as stand alone mode)

(1) The pre-built wireless M-Bus standalone binary can be found in the debug_RF_only directory. Flashing instructions are given in Section 4.3.1.

(2) Zero-Configuration GUI is used to run PLC node as a mini-DC to start the G3-PLC network. The G3-PLC software package will install the GUI automatically.