如Topic Link Label6.3.9 所示，MCU 已断电，因此必须在进入保持状态前配置从保持状态到仅 MCU 或运行状态的转换。与仅 MCU 状态类似，必须为两个 PMIC 设置 I2C_7 触发条件。此外，在进入保持状态前，必须设置 TPS65941111 GPIO4 (H_DDR_RET_1V1)。本例中使用 TPS65941213 上的 GPIO4 将器件从保持状态唤醒并进入运行状态。

Write 0x48:0x85:0x80:0x7F  // I2C_7 is high
Write 0x4C:0x85:0x80:0x7F
Write 0x48:0x34:0xC0;0x3F  // Set GPIO4 to WKUP1 (goes to ACTIVE state)
Write 0x48:0x64:0x08:0xF7  // clear interrupt of gpio4, write to clear
Write 0x48:0x4F:0x00:0xF7  // unmask interrupt for GPIO4 falling edge
Write 0x4C:0x3D:0x08:0xF7  // set PMICB:GPIO4, H_DDR_RET_1V1
Write 0x48:0x86:0x00:0xFC  // trigger the TO_RETENTION power sequence
After the GPIO4 has gone low and the PMICs have returned to the ACTIVE state
Write 0x48:0x86:0x03:0xFC  // Set NSLEEPx bits for ACTIVE state
Write 0x48:0x64:0x08:0xF7  // clear interrupt of gpio4
Write 0x4C:0x3D:0x00:0xF7  // clear PMICB:GPIO4, DDR_RET

本例中使用 TPS65941213 RTC 计时器将器件从保持状态唤醒并进入运行状态。

Write 0x48:0x85:0x80:0x7F  // I2C_7 is high
Write 0x4C:0x85:0x80:0x7F
Write 0x48:0xC3:0x01;0xFE  // Enable Crystal
Write 0x48:0xC5:0x05:0xF8  // minute timer, enable TIMER interrupts
Write 0x48:0xC2:0x01:0xFE  // start timer, if the timer values are non-zero clear before starting
Write 0x4C:0x3D:0x08:0xF7  // set PMICB:GPIO4, H_DDR_RET_1V1
Write 0x48:0x86:0x00:0xFC  // trigger the TO_RETENTION power sequence
After the RTC Timer interrupt has occurred and the PMICs have returned to the ACTIVE state
Write 0x48:0x86:0x03:0xFC  // Set NSLEEPx bits for ACTIVE state
Write 0x48:0xC5:0x00:0xFB  // disable timer interrupt, clear bit 2
Write 0x48:0xC4:0x00:0xDF  // clear timer interrupt, clear bit 5
Write 0x4C:0x3D:0x00:0xF7  // clear PMICB:GPIO4, DDR_RET