SNAU307A May   2024  – May 2024 LMKDB1204

1.   1
2.   Description
3.   Features
4.   Applications
5.   5
6. 1 Evaluation Module Overview
   1. 1.1 Introduction
   2. 1.2 Kit Contents
   3. 1.3 Specification
   4. 1.4 Device Information
7. 2 EVM Quick Start
   1. 2.1 Hardware Setup
   2. 2.2 Software Setup
      1. 2.2.1 TICS Pro GUI Setup
      2. 2.2.2 Power Up Sequence
   3. 2.3 EVM Measurements
8. 3 Hardware
   1. 3.1 Device Operation Modes
   2. 3.2 EVM Configuration
      1. 3.2.1 Power Supply
      2. 3.2.2 Logic Input and Outputs
      3. 3.2.3 Clock Input
      4. 3.2.4 Clock Outputs
      5. 3.2.5 Status Outputs, LEDs, and Test Points
9. 4 Software
   1. 4.1 TICS Pro LMKDB1204 Software
      1. 4.1.1 Input
         1. 4.1.1.1 Input Selection (CLKIN_SEL Register)
         2. 4.1.1.2 Input Interface Type
         3. 4.1.1.3 Input Termination
         4. 4.1.1.4 Auto Output Disable (AOD)
         5. 4.1.1.5 LOS Event
         6. 4.1.1.6 LOS Readback
      2. 4.1.2 Device Info and EVM Setup
         1. 4.1.2.1 Device Info
         2. 4.1.2.2 EVM Setup
         3. 4.1.2.3 SMBus
      3. 4.1.3 Output
         1. 4.1.3.1 SMBus
            1. 4.1.3.1.1 Output Slew Rate Control
         2. 4.1.3.2 OE and ZOUT_SEL Pin Control
10. 5 Implementation Results
    1. 5.1 Typical Phase Noise Characteristic
11. 6 Hardware Design Files
    1. 6.1 Schematics
    2. 6.2 PCB Layouts
    3. 6.3 Bill of Materials (BOM)
12. 7 Compliance Information
    1. 7.1 Compliance and Certifications
13. 8 Additional Information
    1. 8.1 Trademarks
14. 9 References
15. 10Revision History

LMKDB1204 Evaluation Module