SLUAAM4 December   2023 BQ76905 , BQ76907

1.   1
2.   Abstract
3.   Trademarks
4. 1Direct Commands
   1. 1.1 Alarm Enable - 0x66
   2. 1.2 Cell 1 Voltage - 0x14
   3. 1.3 Internal Temperature - 0x28
   4. 1.4 CC2 Current - 0x3A
   5. 1.5 Direct Command Summary
      1. 1.5.1 Disabling Auto Refresh
5. 2Subcommands
   1. 2.1 DEVICE_NUMBER - 0x0001
   2. 2.2 FET_ENABLE - 0x0022
   3. 2.3 RESET - 0x0012
   4. 2.4 CB_ACTIVE_CELLS - 0x0083
   5. 2.5 Subcommand Summary
6. 3Reading and Writing RAM Registers
   1. 3.1 Read Enabled Protections A
   2. 3.2 Enter CONFIG_UPDATE Mode
   3. 3.3 Write Enabled Protections A
   4. 3.4 Write VCell Mode
   5. 3.5 Exit CONFIG_UPDATE Mode
   6. 3.6 Reading and Writing RAM Registers Summary
7. 4I2C With CRC
8. 5Simple Code Examples
9. 6References

BQ7690x Software Development Guide