These 10-bit edge-triggered D-type flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. These devices are particularly suitable for implementing wider buffer registers, I/O ports, bidirectional bus drivers with parity, and working registers.
On the positive transition of the clock (CLK) input, the Q outputs are true to the data (D) input.
A buffered output-enable (
) input can place the ten outputs in either a normal
logic state (high or low logic levels) or a high-impedance state. The
outputs also are in the high-impedance state during power-up and
power-down conditions. The outputs remain in the high-impedance state
while the device is powered down. In the high-impedance state, the
outputs neither load nor drive the bus lines significantly. The
high-impedance state and increased drive provide the capability to
drive bus lines without interface or pullup components.
does not affect
the internal operation of the flip-flops. Old data can be retained or
new data can be entered while the outputs are in the high-impedance
state.
The SN54ALS29821 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ALS29821 is characterized for operation from 0°C to 70°C.
| Type | Title | Date | ||
|---|---|---|---|---|
| * | Data sheet | 10-Bit Bus Interface Flip-Flops With 3-State Outputs datasheet (Rev. B) | 01 Jan 1995 |
Content is provided "as is" by TI and community contributors and does not constitute TI specifications. See terms of use.
If you have questions about quality, packaging or ordering TI products, see TI support.