4 修订历史记录
Changes from * Revision (December 2017) to A Revision
- 更改了数据表标题Go
- 更改了特性列表中的项目Go
- 更改了第一节Go
- 更改了说明 部分中的内容Go
- Changed the descriptions for the GCLK, OUTBx, OUTGx, OUTRx, SENSE, and Thermal pad rows of the Pin Functions table Go
- Deleted a sentence and added a paraagraph at the end of the Grayscale Configuration sectionGo
- Changed the section title from Display Timing Reset to PWM Auto Repeat and changed the textGo
- Changed the section title from Auto Display Repeat to PWM Timing Reset and changed the textGo
- Deleted "and PWM" from section title "LED and PWM Diagnostics"Go
- Changed Table 1Go
- Changed the text following Table 1Go
- Changed the Table 2 dolumn headersGo
- Changed the Table 3 table headers and the text following the tableGo
- Changed "two kinds" to "two sets" in the sentence immediately following Table 3Go
- Changed the text preceding Table 6Go
- Added a table note to Table 6Go
- Deleted the first sentence following Table 6Go
- Changed the text and deleted two tables in the Adjacent-Pin-Short Check section Go
- Added text and two tables following Table 8Go
- Changed the text of the IREF Short and IREF Open Detection sectionGo
- Changed the contents of the OUTUT column in Table 11Go
- Changed the text in the Pre-Thermal Warning Flag sectionGo
- Changed the text in the Thermal Error Flag sectionGo
- Changed the text and deleted a diagram in the Negate Bit Toggle sectionGo
- Changed the text and deleted a diagram in the LOD_LSD Self-Test section Go
- Changed the text in the ERROR Clear sectionGo
- Changed the text in the Global Reset sectionGo
- Changed the LED supply voltage from 7 V to 8 V in the Power Up sectionGo
- Added the TEF register, where the overtemperature fault is latchedGo
- Added a sentence to paragraph 2 of the Register Write and Read section, changed "data" to "288-bit data", and changed "last SCK rising edge" to "288th SCK rising edge"Go
- Changed "data" to "288-bit data" in the FC-BC-DC Write sectionGo
- Changed "sink current" to "APS current" and added "APS detection time" to the definition for bits 200 and 199, respectivelyGo
- Deleted two equations preceding Table 16Go
- Changed the titles of Table 16, Table 17, and Table 18Go
- Added Equation 5 to calculate duty cycleGo
- Changed "OUTB0" to "OUTG0" for bits 167–156 in Table 19Go
- Changed the last sentence of the Special Command Function sectionGo
- Changed the wording and deleted three figures in the Register Maps section Go
- Changed bit numbers 287 and 286 to 277 and 276 in Figure 28Go
- Changed "Output slew rate" to "Output slew-rate time" for bit 203Go
- Changed the text in the Typical Application sectionGo
- Added a sentence and a figure to the Detailed Design Procedure section Go
- Added the Application Curves section to the data sheetGo
- Changed the LED supply voltage from 7 V to 8 V and added a sentence to the Power Supply Recommendations section Go
- Added positioning information for the IREF resistor to the Layout Guidelines sectionGo