SLAU723A October 2017 – October 2018 MSP432E401Y , MSP432E411Y
GPIO ADC Control (GPIOADCCTL)
This register is used to configure a GPIO pin as a source for the ADC trigger.
Note that if the Port B GPIOADCCTL register is cleared, PB4 can still be used as an external trigger for the ADC. This is a legacy mode which allows code written for previous devices to operate on this microcontroller.
GPIOADCCTL is shown in Figure 17-27 and described in Table 17-34.
Return to Summary Table.
31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 | 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
RESERVED | ADCEN | ||||||||||||||||||||||||||||||
R-0x0 | R/W-0x0 | ||||||||||||||||||||||||||||||