SLVUBX8B October   2020  – December 2021 TPS2661

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 EVM Features
    2. 1.2 EVM Applications
  3. 2Description
  4. 3Schematic
  5. 4General Configurations
    1. 4.1 Physical Access
    2. 4.2 Test Equipment and Setup
      1. 4.2.1 Power Supplies
      2. 4.2.2 Meters
      3. 4.2.3 Oscilloscope
      4. 4.2.4 Loads
  6. 5Test Setup and Procedures
    1. 5.1 Overload Protection Test
    2. 5.2 Output Short-Circuit Test
    3. 5.3 Input Undervoltage Protection Test
    4. 5.4 Output Undervoltage Protection Test
    5. 5.5 Output Overvoltage Protection Test
    6. 5.6 TPS26612 Overload Protection Test
    7. 5.7 Current Limiting for VIN < –Vs
    8. 5.8 Surge Protection Test (Current Input, CH1)
    9. 5.9 Surge Protection Test (Analog Output, CH2)
  7. 6EVAL Board Assembly Drawings and Layout Guidelines
    1. 6.1 PCB Drawings
  8. 7Bill Of Materials (BoM)
  9. 8Revision History

Revision History

Changes from Revision A (March 2021) to Revision B (December 2021)

  • Updated note in the Abstract sectionGo
  • Added current limit behavior of TPS26613Go

Changes from Revision * (October 2020) to Revision A (March 2021)

  • Added note on the need of TVS diodes U6 and U7 when the burden resistor is floating.Go
  • Updated Figure 3-1 Figure 3-1 .Go
  • Updated Table 5-1 Table 5-1.Go
  • Replaced Figure 5-1 Figure 5-1 as per the revised EVM.Go
  • Added surge test waveforms and Surge Protection Test (Current Input, CH1) section.Go
  • Added surge test waveforms and Surge Protection Test (Analog Output, CH2) section.Go
  • Updated TPS2661EVM board assembly and layer images in Section 6.1 .Go
  • Updated bill of materials.Go