4 Revision History
Changes from Revision C (May 2020) to Revision D (November 2023)
- 更新了整个文档中的表格、图和交叉参考的编号格式Go
Changes from Revision B (September 2016) to Revision C (May 2020)
- 将汽车特性 移至“特性”列表顶部Go
- Added Junction temperature to the Absolute Maximum Ratings
Go
- Changed the ESD Ratings tableGo
- Added INTZ Report to the Electrical Characteristics tableGo
- Changed Figure 7-1
Go
- Changed From: "The load diagnostic function runs on de-assertion" To: "The load diagnostic function runs on assertion" in the Load Diagnostics sectionGo
- Added the Protection and Monitoring sectionGo
- Changed From: "NRST pin..." To: "EN pin..." in the Operation in Shutdown Mode sectionGo
- Chaged From: When EN is asserted (logic low) To: When EN is de-asserted (logic low) in the Operation in Shutdown Mode sectionGo
- Deleted register 0x00 from the Register Map sectionGo
- Changed register Address: 0x03
Go
- Changed the Single-Ended Source section and Figure 8-1
Go
- Changed from: BSTA and BSTB to: BSTP and BSTN in the Capacitor Selection sectionGo
- Changed the Differential Input Diagram section and Figure 8-6
Go
Changes from Revision A (June 2016) to Revision B (September 2016)
- 将“特性”从“符合汽车级 (Q100) 标准”更改为:“通过 AEC-Q100 2 级鉴定”Go
- 将“特性”从“宽工作电压范围 (5V 至 18V)”更改为:“宽工作电压范围 (4.5V 至 18V)”Go
- 添加了特性:ISO9000:已通过 2002 TS16949 认证Go
- Changed the VDD MIN value From: 5 V to: 4.5 V in the
Section 6.3
Go
- Changed From: operates from 5 V – 18 V To: operates from 4.5 V – 18 V in the
Section 9
Go
Changes from Revision * (June 2016) to Revision A (June 2016)